Shenzhen Wejoin Mechanical & Electrical Co.
A Professional Security Products Supplier! Your Best Security Partner!
Add to Cart
1800kg ac control board electric gate motors for sliding door
Main Features
AC motor with built-in control unit
Keypad/single button interface
Alarm lamp, photo beam and safety beam interface
User can select auto-close function
Soft start and slow stop(smart version, optional)
Auto-reverse function when hitting obstacle during closing(smart version, optional)
Manual key release design for emergency power failure
Specifications
| Model | WJKMP202 | |
| Voltage | 220V±10% | 110V±10% |
| Frequency | 50HZ | 60HZ |
| Current | 2.7A | 5.8A |
| Motor voltage | AC220V / 110V | |
| Capacitor | 20μf | 60μf +14μf |
| Output Power | 350W | |
| Absorbed power | 594W | 638W |
Motor base and it's installation
1. Motor base installation: set the installation position of the base tray according to the size of the motor and the height of the installation position of the gear rack. Then Embed the bolts in advanced or use the expansion bolts to embed the base into the cement foundation.
2. If the gear rack has already been installed, fix the motor to th base and turn the clutch with the clutch key to the off position, then make the gear of the motor suit right to the gear rack, then the position of the base can be set. Take off the motor and fix the base.
Rack installation
Make the gear of the gear rack towards the floor. Make the gear of the rack fit the gear of the motor. Fasten the gear rack to the door with the screws. Push the gate and make it move the whole route Fasten the gear to the gate after assuring that the gate run smoothly the whole route
Rack is usually installed piece after piece. To avoid dithering or blocking, please adjust the gap of the gear rack. We suggest one way( refer to Fig-3): fix up the rack1 and rack after adjusting the two racks with the small adjusting rack
