Shenzhen Wejoin Mechanical & Electrical Co.
A Professional Security Products Supplier! Your Best Security Partner!
Add to Cart
100% Duty Cycle High-Performance Car Park Barrier Gate for Parking Facility Security
Automatic Barrier Gate Brief Introduction
The product consists of four parts: cabinet, transmission mechanism, control unit, and boom. It distinguishes between left-installed and right-installed, and it is used in parking lot entrance and exit control systems.
This product is divided into three types: barrier gate with straight boom, barrier gate with folding boom, and barrier gate with fence boom.
Boom Barrier Technical Data
1. Working temperature (motor): -35℃~ + 70℃
2. Power supply input voltage: AC100~264V
3. Controller input voltage: DC24V±10%, 7.5A
4. Motor power: 180W
5. Relative humidity: 30%~80%, no condensation
6. Distance of remote control: open and undisturbed, L≤50M
7. Running speed: 1.5~6 seconds adjustable
8. MTBF: 3,000,000 times
| Boom Type | Boom Length (Meters: M) | Spring Diameter Φ (mm) |
| Straight Boom without Rubber | 6≥L≥4.8 | Φ5.5+Φ4.5 |
| 4.8＞L≥3.5 | Φ5.5 | |
| 3.5＞L≥2.5 | Φ4.5 | |
| Straight Boom with Rubber | 6≥L＞5.3 | Φ6.8+Φ4.5 |
| 5.3≥L≥4.3 | Φ5.5+Φ4.5 | |
| 4.3＞L≥3.5 | Φ4.5+Φ4.5 | |
| 3.5＞L≥3 | Φ5.5 | |
| 3＞L | Φ4.5 |
Barrier Gate Controller Interface
1. Wire Control Interface:
This interface is available for parking system, also available for external controller to control barrier gate.
2. Anti-smashing Interface:
Infrared Photocell: Boom will lift up when short circulate "Infrared photocell" and "GND" interfaces during boom falling down.
Loop Detector: Boom will lift up when short circulate "loop detector" and "GND" interfaces during boom falling down; when boom moves to up limit position, boom will fall down after "loop detector" and "GND" interfaces disconnected.
3. Relay Output Interface:
The relay output can be set to meet different application requirements by setting the output mode. For details, please refer to item H-16 of advanced settings. The default is that the limit signal output is as follows:
When the barrier opens to up limit position, the COM and LmO are connected;
When the barrier closes to down limit position, the COM and LmC are connected;
During the opening and closing, COM and LmC, LmO are disconnected.
